Archive for April, 2015

When one buys a new detector it takes time, patience and experience to get comfortable with your new machine. It helps if you buy your detector from Gerry at http://gerrysdetectors.com/ . Gerry will take the time to help you and does have one day classes for coin machine detectors. That being said after you are own your own and no one is standing there beside you telling you when to dig or how to adjust your machine life gets a little more difficult. When I started using the CTX 3030 I tried different settings and combinations of those settings. Now understand that no one’s settings will work in every situation. We have to learn when and what to change for the area you are hunting. EMI and wet soil can make a difference on a spot we are working. Say you are hunting under a power line next to the area, there is going to some interference. So you must remember to run your noise cancel (which I do several times a day) to get your machine to run at it’s best. Setting the sensitivity to high or low will effect performance. You can run auto ground balance and not worry about that part but I do not unless all my targets are shallow and the ground is not mineralized. I am going to do a video on how I set up my machine in the near future but for now I will share my settings here. Now understand this is NOT the only way to run your machine it’s what I like and works for me. I do run a tone modified coin mode with the settings below. The tone settings are what I like they do not effect the depth.

Select Coins then:

Audio Mode: Combined & Ferrous Coin

Deep On

Fast Off ( run fast if you are in heavy iron but you will loose depth)

Target Trace OFF you can use it if you like I do not.

Target Trace Pinpoint OFF

Ground Balance Manual . You can use auto but it does not go as deep most of the time.

Volume Gain: 20 lower if you want to really hear the difference between a deep and shallow sized coin target.

Threshold to a lite hum.

Volume limit Max, but I use my head phone volume to protect my ears from the loud signals so set it accordingly. Protect your hearing!

Pitch (your choice) mine is 20 use what you hear best.

Sensitivity set to manual. Start at 20-22 area and increase until your machine gets a little chatty then back it off 1 or 2 numbers. (Sometimes it will have to be less.)

You can use Auto and if I do I run +3 but it does not go as deep most of the time but your machine will be some what more stable and give more consistent VDI #’s.

Hope this helps some of you on your quest.

Ron

Advertisements